2007 rx8 manual 6-speed stormy blue mica
Hi everyone, Ive read through a few posts...some where helpful. Based upon a few suggestions, Ive replaced the (4) coils, (4) wires, (4)plugs with all new parts...pretty easy work really.
Experiencing Same Problem EVEN AFTER said new parts installed:
The 8 starts fine: Not a quick start/not hard start either. Call it a mild start (2-3 second start-up). Some coughing-sputtering out exhaust past couple weeks experience weather temp changes in WI.
No Engine Check Lights before start. No Engine Check Light when driving. The other day, the temp dropped from 50-70F to 28F... in a few hours, no big deal the car does just fine for WI winters...It sat outside for about 3 hours in 28F (its used to being garaged 50F). But it started right up, it warmed up, and then I casually drove it home.
Drove home 19-24 miles on country roads, a few stop-and-go lights 35-50mph max with No Engine Check Lights present. I could come to a good stop, yet once ready to gradually accelerate, the rpms revved up normally, but the revs needed to stay higher- longer for it to physically increase its speed. As if it had some power/acceleration lag.
Curious, because its 6-speed manual, I question the clutch slipping/not fully release/engage motor to convert power?
- something not fully engaging the rotary power?
- Is there a Clutch Adjustment perhaps I should check?
- what else would cause this when Ive replaced coils, wires, and plugs?
Please HELP.
I was thinking possibly the trans fluid is low(?) - low compression?
Honestly, I have not had anything major/mechanical/ELE go wrong with this 2007 RX8, and have driven it from about 52K miles to 84k without any issues (2.5-3 years).
What else could it be that's causing this lag/lack of acceleration when there's no Engine Check Light present?
Thank you in advance!
Hi everyone, Ive read through a few posts...some where helpful. Based upon a few suggestions, Ive replaced the (4) coils, (4) wires, (4)plugs with all new parts...pretty easy work really.
Experiencing Same Problem EVEN AFTER said new parts installed:
The 8 starts fine: Not a quick start/not hard start either. Call it a mild start (2-3 second start-up). Some coughing-sputtering out exhaust past couple weeks experience weather temp changes in WI.
No Engine Check Lights before start. No Engine Check Light when driving. The other day, the temp dropped from 50-70F to 28F... in a few hours, no big deal the car does just fine for WI winters...It sat outside for about 3 hours in 28F (its used to being garaged 50F). But it started right up, it warmed up, and then I casually drove it home.
Drove home 19-24 miles on country roads, a few stop-and-go lights 35-50mph max with No Engine Check Lights present. I could come to a good stop, yet once ready to gradually accelerate, the rpms revved up normally, but the revs needed to stay higher- longer for it to physically increase its speed. As if it had some power/acceleration lag.
Curious, because its 6-speed manual, I question the clutch slipping/not fully release/engage motor to convert power?
- something not fully engaging the rotary power?
- Is there a Clutch Adjustment perhaps I should check?
- what else would cause this when Ive replaced coils, wires, and plugs?
Please HELP.
I was thinking possibly the trans fluid is low(?) - low compression?
Honestly, I have not had anything major/mechanical/ELE go wrong with this 2007 RX8, and have driven it from about 52K miles to 84k without any issues (2.5-3 years).
What else could it be that's causing this lag/lack of acceleration when there's no Engine Check Light present?
Thank you in advance!
2007, manual 6 speed manual trans - it lags power
0 commentaires:
Enregistrer un commentaire