I'd like to buy a usable center iron. The surfaces should ideally be flat with no
gouges, scrapes, cracks, or damage which will allow combustion gas to leak. There shouldn't be
much rust, corrosion, and weathering in the areas of the plate used to transfer and seal coolant.
I'd prefer an iron out of an engine that did not overheat, and if you could post pics, I'd appreciate it. I don't know if it matters,
but my car is the 6pd MT sold in the US. I believe irons are the same for AT & MT.
Fine Print:
I'm chiefly interested in buying from people who are active on this forum,
have a good reputation, and have successfully completed trades on the forum before. Lastly,
I will be buying the part on the October 8th or 9th. Just throwing this out there in the ether to
hopefully have a seller lined up.
Thanks
gouges, scrapes, cracks, or damage which will allow combustion gas to leak. There shouldn't be
much rust, corrosion, and weathering in the areas of the plate used to transfer and seal coolant.
I'd prefer an iron out of an engine that did not overheat, and if you could post pics, I'd appreciate it. I don't know if it matters,
but my car is the 6pd MT sold in the US. I believe irons are the same for AT & MT.
Fine Print:
I'm chiefly interested in buying from people who are active on this forum,
have a good reputation, and have successfully completed trades on the forum before. Lastly,
I will be buying the part on the October 8th or 9th. Just throwing this out there in the ether to
hopefully have a seller lined up.
Thanks
{WTB} Center Iron
0 commentaires:
Enregistrer un commentaire