I have a 2006 AT RX8 with 100k miles om the original renesis that i've owned for a little less than a year now and the problems are pilling up now. I've replaced plenty of parts, i check my fluid levels everyday, oil changed every 2000miles. coils, plugs, wires, rad, fans, trans cooler, thermostat, andwaterpump all have less then 10k miles.
For the past 2 weeks the car as been constantly flooding and misfiring like crazy. My battery was weak so i replaced that with an optimum red top and the problem went away for a few days, car was back to normal and the feel was great. One night iwent to start it after work, and it cranked and cranked and cranked i gave up and called for a tow truck. After i do the deflood procedure it starts up (after about 10 mins) but the cel flashes and there is 0 throttle response this goes on for about three minutes along with a very rough idle until it finally stalls out and becoms hard to start again. I then do the 20 brake pedal stomp, along with the deflood procedure and the car turns on and idles roughly for about a minute and the cel does not blink or turn on. After this the car runs great as if nothing was ever wrong for a day or two and then back to the same crap!
I need help! I've been reading the forums for a while now and everyone seems to have knowledge about one problem or the other but nowhere have a read the exact same thing. I had the codes read before replacing the battery and they were p0301, p0506, p0506p, p050a
For the past 2 weeks the car as been constantly flooding and misfiring like crazy. My battery was weak so i replaced that with an optimum red top and the problem went away for a few days, car was back to normal and the feel was great. One night iwent to start it after work, and it cranked and cranked and cranked i gave up and called for a tow truck. After i do the deflood procedure it starts up (after about 10 mins) but the cel flashes and there is 0 throttle response this goes on for about three minutes along with a very rough idle until it finally stalls out and becoms hard to start again. I then do the 20 brake pedal stomp, along with the deflood procedure and the car turns on and idles roughly for about a minute and the cel does not blink or turn on. After this the car runs great as if nothing was ever wrong for a day or two and then back to the same crap!
I need help! I've been reading the forums for a while now and everyone seems to have knowledge about one problem or the other but nowhere have a read the exact same thing. I had the codes read before replacing the battery and they were p0301, p0506, p0506p, p050a
0 commentaires:
Enregistrer un commentaire