High 5 , Back flip , chest bump happy

jeudi 19 mars 2015

UPDate

I over heated my 8 a while back , Had to get a rebuild budget together .

Took engine out this week , took it to rebuilders today , We opened engine up . I was afraid of the loud POP I had heard when I put water in engine .

I was very impressed with Micheal Edwards today he and his guys unloaded my engine and opened her up in about an hour , Cleaned up plates and rotor housings enough to judge the condition of each piece . Micheal said they were a 9 out of possible ten . :)

All plates and rotor housings are in Very good condition ! No groves or flaking on housings , Water seal failure was evident !! Plates had acceptable minor wear .

There was some bearing wear . So I am going to replace the e shaft , rotor bearings , main bearings ,

Heavy duty water seals from Pineapple , oil pan gasket ,oil control ring set . All from Pineapple

From Atkins

Apex seals and side seals , corner seals , and springs , upping oil pressure , complete gasket kit .. ect

I believe my own eyes . With the XRT stage two clutch , in an RX8 raced over 150 hours and counting in endurance events , Redlined every gear ... Ill take the chance !

I have picked up a new factor hood and a factory front bumper to replace the Duraflex

I can't wait to get her running again !!!!

Big *** grin !!




0 commentaires:

Enregistrer un commentaire

 

Lorem

Ipsum

Dolor