Hey everyone, I just bought my 04 rx8 6spd. I bought it knowing there was an engine issue and just wanted it for a project and toy for the summer.
Well i'm getting CEL PP0037, PP0410, PP0138 and PP2259.
CEL PP0410 and PP0138 go away after a few minutes warming up, but PP0037 and PP2259 remain.
The car idles fine and works good revving up to 4000rpm then it just wont go further as much as i press on the gas pedal.
The issue i know about is that my air pump is not working at all, even on cold start ups. Also the previous owner added a gutted cat/test pipe into the car which could be throwing the PP037. From what i have read both of these issues should not put the car into "limp" mode if i'm reading correctly.
I'm curious what you all think the issue may be, i have ran the car with the cat removed to make sure there was no blockage further down the exhaust. Also the previous owner just changed the coils. Any feed back would be great!
Well i'm getting CEL PP0037, PP0410, PP0138 and PP2259.
CEL PP0410 and PP0138 go away after a few minutes warming up, but PP0037 and PP2259 remain.
The car idles fine and works good revving up to 4000rpm then it just wont go further as much as i press on the gas pedal.
The issue i know about is that my air pump is not working at all, even on cold start ups. Also the previous owner added a gutted cat/test pipe into the car which could be throwing the PP037. From what i have read both of these issues should not put the car into "limp" mode if i'm reading correctly.
I'm curious what you all think the issue may be, i have ran the car with the cat removed to make sure there was no blockage further down the exhaust. Also the previous owner just changed the coils. Any feed back would be great!
1 commentaires:
Thanks for your great information, the contents are quiet interesting.I will be waiting for your next post. Rotary Actuators Manufacturers | Helical Rotary Actuator
Enregistrer un commentaire