I am going to start searching after I post this as I am panicking currently. While replacing my ignition coils I was securing the new set on when I sheared the threading off of the plate/tray that hold the ignition coil. The bolt I was putting back on was the original and was rusted so it wasn't going on smoothly.
Is the contact between the ignition coil and that plate imperative? Can I run with one just a little loose in the mean time?
Edit:
Searching would of been faster than typing this:
http://www.rx8club.com/series-i-tech...ptions-243789/
Is the contact between the ignition coil and that plate imperative? Can I run with one just a little loose in the mean time?
Edit:
Searching would of been faster than typing this:
http://www.rx8club.com/series-i-tech...ptions-243789/
0 commentaires:
Enregistrer un commentaire