I installed four amber LED's to each headlight and tail light, and as expected, got the hyperspeed turn signal. I read some other threads and installed wirewound resistors (10W, 10 ohm) from radioshack, soldered some wires to each resistor, and spliced each resistor to each turn signal using wire taps.
They still blink fast. I checked to see if the resistors were getting hot, and sure enough the back two resistors (the one's on the tail lights) were so hot I couldn't touch them for too long.
The front ones however, were mildly warm, but just barely.
Any ideas? Couldn't find someone with the same issue.
They still blink fast. I checked to see if the resistors were getting hot, and sure enough the back two resistors (the one's on the tail lights) were so hot I couldn't touch them for too long.
The front ones however, were mildly warm, but just barely.
Any ideas? Couldn't find someone with the same issue.
0 commentaires:
Enregistrer un commentaire