Ive been trying to chase down why my car won't stay running.it starts hard when cold, then will run for 15-20 minutes, then stall. If I give it gas it'll rev up, then choke out and stall. No codes. It was suggested I check injector wiring. So after removing all of the upper intake manifold, I made 2 discoveries. One of my hard plastic omp lines is broken. Secondly (and I don't know if this is normal) my fuel injectors are really loose. They can just spin and turn freely in the ports. It is also wet with fuel around them. The omp line I'm not too worried about because I am running pre mix, but is it creating a vacuum leak? Are the injectors supposed to be tightened down?
2 potential problems...
0 commentaires:
Enregistrer un commentaire